SPF100 - 3/8" Seismic Pivot Fitting

Standard Dimensions:

• Hole Diameter: 9/16" (14mm)
• Hole Spacing (From End): 13/16" (21mm)
• Hole Spacing (On Center): 1-7/8" (48mm)
• Width: 1-5/8" (41mm)
• Thickness: 1/4" (6mm)

Note:

When used for mechanical supports, load capacities of brackets and fittings should be in compliance with the American Standard Code for Pressure Piping.

FINISH Electro-galvanized (EG), conforming to ASTM B633 Type III SC1.

Safety factor - 3

1. Design load is limited to slip capacity of a channel nut at hole "R".
2. Allowable loads have been determined by the manufacturers testing, analysis and technical specifications.
3. For retrofit application, engineer of record must verify.
4. Patented.
5. Square washer provided with fitting.
6. When a hanger rod is thru-bolted (in lieu of channel nut installation), higher transverse loads may be transmitted due to the higher allowed rod shear loads compared to channel nut slip values. This higher load may be used with verification through engineering calculations.